Tin Plating Copper End Caps For Fuse

Mechanical properties of Tin Plating Copper End Caps for Fuse

Density g/cm³: 8.9

Copper strip of Copper Slip Cap Fitting in (M, Y4, Y2, Y, T) state, thickness ≥0.2mm, tensile strength Rm/Mpa (≥195-350), elongation after break % (≥3-30), hardness HV: 60-120.

Fuse Contact and Outer Copper Cap are plated with matte tin

1. The surface layer of Matte Tin Fuse Terminals look like fog, a little foggy, and the crystals are relatively rough, which is easy to leave fingerprints. The thickness of Matte Tin Contact for Fuse is generally 5um or 8um (the thickness can be selected according to the application).

2. Matte Tin Fuse Terminal Contact has better solderability and tin resistance than Bright Tin Fuse Contact, but it is easy to scratch and leave fingerprints.

3. Generally, Matte Tin Automotive Fuse Terminal is selected for single-use workpieces, and Bright Tin Fuse Terminal Contact is generally selected for workpieces that require solder but belong to appearance parts.

Our bright tin plated copper pipe caps meet the highest quality requirements as stipulated in ISO9001, IATF16949, SGS guidelines and our stringent quality control system.

Tin-plating fuse caps and contacts packaged as delivered can be stored for one year from the date indicated on the packing label under the following conditions:

1）Temperature:-15 °C- +30°C (no condensation) 

2）Humidity :85% RH or less

3）Not exposed to corrosive gas or sea breeze 

4）No visible dust 

5)Not exposed to direct sunlight 

6)Load:No application of load that may cause deformation or degradation of the product.

Etiquetes populars: Caps finals de coure de placa de llauna per a fusibles, Xina, fabricants, proveïdors, fàbrica